HELP!! did i BREAK the Trace?

[iboner]

I posted in bugeneral but thought i get better repseone here. I was in unlocker and tried to connect test point with needles. only it was saying connect at testpoints so i scratched a little harder. now when i run it, says BUS ERROR. did i damage the trace?? HELP

[Diet]

can't tell you from here if you actually broke it - use a magnifying glass and try to find out. "bus error" sounds like broken trace - but I also got a "bus error" when trying the needle method and after doing a full restore it was fine again.
if it's really broken just remove *carefully* a bit more of the solder stop mask and solder a small piece of wire over the place where it's broken. that should do it.

[glen.tw]

I posted in bugeneral but thought i get better repseone here. I was in unlocker and tried to connect test point with needles. only it was saying connect at testpoints so i scratched a little harder. now when i run it, says BUS ERROR. did i damage the trace?? HELP

I got "Bus Error" because I forgot to upload "testcode.bb" to /usr/bin (same folder as iunlocker).

[Da Fox!]

Also check if all the files got CHMOD 755

[iboner]

What actually happens when you break a trace ? Or acccidently touch the trace next to the correct one. My phone is acting weirder than normal, but can never get pass "connect at testpoints" now i can restore fine and get up to ieraser, but it will either say can't write or bus error. Please help, I did everything exact even chmod all files.