[1.1.1 (1.1.2 OTB)] HW unlock step 3 error: Can't write data

[Strayliight]

Hi there.
I have some experience in hardware hacks, so I gave the guide a shot, but at step three where i'm suposed to enter

cd /usr/bin
ienew

into the console, i get the following message:

# Resetting the baseband...Done
# Opened: /dev/tty.baseband
# ieraser for 112OTB: tool by geohot
# Waiting for data...
# Can't write

Any sugestions?

I downgraded to 1.1.1, jailbroke, installed BSD subsystem, term vt 100 and Bootloader downgrade. opened the phone, entered flight mode and here we are...
I'm not suposed to connect the testpoints untill step 4 right...

-peace

[GeeZuZz]

Can you run bbupdater -v and post results?

[kIREmK]

first: sry for my bad english :D

same problem

bbupdater -v

resetting target...
Error: Failed to initialize comm layer:
done

Edit:

Have you unload these plist? After i do this, it goes.

Step 3: Erase baseband

Go to Settings on your phone and turn on Airplane Mode (if you use SSH, enter this command instead: launchctl unload /System/Library/LaunchDaemons/com.apple.CommCenter.plist) . Then launch the terminal by tapping the Term-vt100 icon on your springboard.
Type these command:

cd /usr/bin/
ienew

EDIT:
NEW PROBLEM:

iunew

the iphone ask me "did you erased your flash first?"

What i am making wrong?

[madB]

dude i had the exact same problems. including did u erase your flash first

i restored to 1.1.1 and now back to 1.0.2 and gonna try all over again

PLS let me know how u solve it

[Anarchy]

If youve updated to 113 it should write that error :)