Problems with Dynamite Programmer + Woron Scan

[adam-james]

Hi All,

I got my Dynamite Programmer in the post this morning. It has both USB and Serial, but I have not managed to get it installed via Serial yet.

Please could someone go into more detail about this stage of the process.

I have a v1 card, but can't get Woron Scan to even see it.

My questions:

Do I select 'PC SC CARD', 'Phoenix Card' or 'a38 Simulator' to get it wotking with the Dynamite Programmer.

Here is the output from the program after using all methords:

IMSI :Communication problem... closing COM port...
The real speed is 9600..
There is a no Phoenix device or card inserted...
Communication problem... closing COM port...
Can't select 3F00 file
PC/SC Smart Card error 00000006
Can't select 3F00 file

I noticed that you can't select USB from the option menu, just COM 1 etc... so do i NEED to use a com port?

If so, how did you guys get this working. I dont even have a red light when it's attached to the com port.

Thanks for your time.

[chinaet]

try difference serial speed

[teamare2006]

check in the device manager comport shoud be in 1 to 9 range if the comport is other than this it will going to give the erroe

[adam-james]

Thanks for replies...

So i SHOULD be using the SERIAL connection only? I don't need the usb to power it?

I checked an my computers com port is in device manager as com 1 .. and it's speed is 9600

[Sassha]

Thanks for replies...

So i SHOULD be using the SERIAL connection only? I don't need the usb to power it?

I checked an my computers com port is in device manager as com 1 .. and it's speed is 9600

Ok, here is how! I used Dynamite! First,connect programer with USB AND with Serial!

If u didnt download this,download it,and install - http://206.53.51.55/duolabs/CIS82.zip

Then Run Cas Interface Studio 8.2, Click Utilities---PHONEIX. If u will use Woronscan select Phoneix@3.579 Mhz.....for Sim-Emu 6.01 Configurator v2.1 select Phoneix@6.00Mhz.

[adam-james]

Perfect! Thanks dude. I am searching for my ki right now...

[ashraf@samawi.com]

got my dynamite... downloaded CIS82, selected Pheonix@3.579 and still woroscan doesn't read... i still get

IMSI :Communication problem... closing COM port...
The real speed is 9600..
There is a no Phoenix device or card inserted...
Communication problem... closing COM port...
Can't select 3F00 file

... i tried every com port at every speed...

any suggestions?

[ashraf@samawi.com]

in the device manager, it shows two com ports com 1 and com 2... i try both of them with woronscan and still that same error...

do i have to configure these com ports a special way?

I have waited 2 weeks for the super sims and dynamite and I can't get the pc to even see the **** thing....

Please.... someone help

[ashraf@samawi.com]

no has any clue? how do i check which com ports are open and how can i make sure one is assigned to the dynamite?