kakayo
06-19-2006, 08:54 PM
My setup is as follows
10.4.6 it was zipped to be 3.85gigs but it extracts to 4.35gigs approx. It seem to be semjazaa. because of the install options I found.
p4 2.8c
p4c800 deluxe
1 gig twin 512 Corsair 433 mhz
Seagate sata hd w/3part
gforce 6800
netgear WG311T (not working yet)
haven't tried onboard nic but I imagine I have to patch that too, I haven't tried audio either, not priorities right now. My priority is wifi with netgear WG311T.
I've searched different forums on the patching or using of this particular card, but I am yet to find a clear and complete way to make this card work.
It has the patch that came in my install disc but I doesn't see the card. When in the install, I use the network utility, I can see the card but I can't change anything and after install of the OS is successful I can't see the card.
It seems to be in the eno 0 position.
I don't know the chip number itself but I can find out on my winXP partition in which the wifi works like a charm.
I'm a noob to the whole kext and terminal procedures but I follow instructions if they are clear. I've had success before when I could get a wired nic card to work, but this is a new install, so I want to go wifi from scratch, later, after I get wifi working, I will work with my video card resolutions and whatnot.
any help and info will be greatly appreciated. If a clear set of instructions has been posted somewhere please point me in the right direction, I don't want to cause any excess work.
10.4.6 it was zipped to be 3.85gigs but it extracts to 4.35gigs approx. It seem to be semjazaa. because of the install options I found.
p4 2.8c
p4c800 deluxe
1 gig twin 512 Corsair 433 mhz
Seagate sata hd w/3part
gforce 6800
netgear WG311T (not working yet)
haven't tried onboard nic but I imagine I have to patch that too, I haven't tried audio either, not priorities right now. My priority is wifi with netgear WG311T.
I've searched different forums on the patching or using of this particular card, but I am yet to find a clear and complete way to make this card work.
It has the patch that came in my install disc but I doesn't see the card. When in the install, I use the network utility, I can see the card but I can't change anything and after install of the OS is successful I can't see the card.
It seems to be in the eno 0 position.
I don't know the chip number itself but I can find out on my winXP partition in which the wifi works like a charm.
I'm a noob to the whole kext and terminal procedures but I follow instructions if they are clear. I've had success before when I could get a wired nic card to work, but this is a new install, so I want to go wifi from scratch, later, after I get wifi working, I will work with my video card resolutions and whatnot.
any help and info will be greatly appreciated. If a clear set of instructions has been posted somewhere please point me in the right direction, I don't want to cause any excess work.