iPhone was unlocked successfully but says "No Service"

[ericlewis91]

My iPhone has 1.1.1. with 4.02.13G and

i used anysim 1.2 to unlock

it said unlock successfull?

but it shows new service?

what can i do?

[belcorriko]

My iPhone has 1.1.1. with 4.02.13G and

i used anysim 1.2 to unlock

it said unlock successfull?

but it shows new service?

what can i do?

You'll have to downgrade to 1.0.2, erase the firmware and write the 3.14.08_G firmware to the baseband, then upgrade back to 1.1.1 to get service again. Search the forums, the directions are out there.

[kazee]

I had the no service issue when I unlocked a 1.0.2 phone with anySIM 1.0.2. The issue showed up the first coupe hours I had the phone, then it stopped. I did absolutely to the baseband. I truly believe its and issue with your service provider not supporting the phone properly. Just give it some time and see if it changes. If not then you may have a more serious problem than I did.

[saucy]

You'll have to downgrade to 1.0.2, erase the firmware and write the 3.14.08_G firmware to the baseband, then upgrade back to 1.1.1 to get service again. Search the forums, the directions are out there.

I had the same No Service issue and that was exactly what I did to fix it.